Inquiry

sulphate content test

How to Analysis Sulphate in Water | Water Treatment

Determination of Sulphate Sulphate ions in water present usually in the form of compounds like CaSO4,MgSO4,Na2SO4 etc. The determination of sulphate ions is water in based on the fact that when water is treated in cold with benzidine hydrochloride solution, the sulphate ions get precipitated as insoluble benzidine sulphate

Learn More

Hydrated Lime Stabilization of Sulfate-Bearing Soils in Texas

content in reducing swell in high-sulfate soils. A sulfate-deficient soil of the Vertisol order with a Plasticity Index (PI) of 24 was chosen as the soil to add selected concentrations of sulfate since that is what underlies a large portion of the Texas Coastal Plain, where most of the sulfate problems have been reported (Figure 2).8 Figure 2.

Learn More

sulfate test kit

Industrial Test Systems eXact 486608 Micro Sulfate Strips, 0-150 ppm Detection Range (Bottle of 50)

Learn More

IS 3025 (Part 24): Method of Sampling and Test (Physical

3.1 Scope and Application - This method is applicable to surface and groundwaters with sulphate concentration in the range 5 to 150 mg/I. Samples having higher concentrations can be measured by appropriate dilution of sample. 3.2 Principle and Theory - Sulphate ion is titrated in an alcoholic solution under controlled acid

Learn More

THRESHOLD SULFATE LEVELS IN SOILS | Recommended Practice for

Although volumetric swell tests are valuable, it is also necessary to have a reliable measure of the sulfate content and to link that level to a threshold risk. The sulfate concentration should be determined based on an accepted specification such as AASHTO T 290 (modified), which is discussed later in this report.

Learn More

DETERMINATION OF SOLUBLE SULPHATE CONTENT IN SOIL (IS-2720

Determination of Soluble Sulphate Content Purpose Sodium sulphate is present in some soils. The salt is easily hydrated and dehydrated under the influence of climatic changes. There are enormous volume changes during this process of hydration and dehydration, which influence the engineering properties of soils. Procedure Take the soil sample in a state in which []

Learn More

CRD-C403-71 Test Method for Determination of Sulfate Ion

METHOD OF TEST FOR DETERMINATION OF SULFATE ION IN SOILS AND WATER 1. Scope 1.1 This method of test covers de-termination of sulfate ion content in soil and water samples. 1.2 The analytical procedure for water samples and for the extracts from soil samples is based on ASTM Designation: D 516, “Methods of Test

Learn More

Sulfate - Wikipedia

The barium derivative is useful in the gravimetric analysis of sulfate: if one adds a solution of most barium salts, for instance barium chloride, to a solution containing sulfate ions, barium sulfate will precipitate out of solution as a whitish powder. This is a common laboratory test to determine if sulfate anions are present.

Learn More

Sulfate Cell Test photometric, 100-1000 mg/L (SO42

This Spectroquant Sulfate Cell Test allows the accurate quantification of the sulfate content in aqueous samples. Method applied: Sulfate ions react with barium ions to form slightly soluble barium sulfate. The resulting turbidity is measured photometrically (turbidimetric method).

Learn More

Sulphate Attack on Concrete - Process and Control of

Sulphate attack on concrete is a chemical breakdown mechanism where sulphate ions attack components of the cement paste. The compounds responsible for sulphate attack on concrete are water-soluble sulphate-containing salts, such as alkali-earth (calcium, magnesium) and alkali (sodium, potassium) sulphates

Learn More

ASTM D516 - 16 Standard Test Method for Sulfate Ion in Water

5.1 The determination of sulfate is important because it has been reported that when this ion is present in excess of about 250 mg/L in drinking water, it causes a cathartic action (especially in children) in the presence of sodium and magnesium, and gives a bad taste to the water.

Learn More

PDF Determining Sulfate Content in Soils — Colorimetric Method

DETERMINING SULFATE CONTENT IN SOILS — COLORIMETRIC METHOD TXDOT DESIGNATION: TEX-145-E CONSTRUCTION DIVISION 5 - 7 EFFECTIVE DATE: FEBRUARY 2005 7. TEST REPORT 7.1 Report average sulfate concentration in ppm to the nearest whole number. PART II—LABORATORY TEST 8. SCOPE 8.1 The following procedure describes preparing soil samples for determining sulfate content

Learn More

What is the Test for Sulphate Ions

Potassium Permanganate Test for Barium Sulphate If barium sulphate is precipitated in the presence of potassium permanganate (KMnO4), it turns to a pink (violet) colour after absor some of the permanganate. The adsorbed permanganate on the surface cannot be reduced using common reducing agents.

Learn More

Tests for negative ions - Testing for ions and gases

Testing for sulfate ions. Sulfate ions in solution, SO 4 2-, are detected using barium chloride solution. The test solution is acidified using a few drops of dilute hydrochloric acid, and then a

Learn More

AASHTO T 290 - Standard Method of Test for Determining Water

This test method covers the determination of the water-soluble sulfate ion content in soil. This standard is divided into two parts. The first part specifies the procedure for sampling and preparing the sample to size for testing. The second part delineates two test procedures (Methods A or B) for the determination of the sulfate ion content in

Learn More

General Chapters: <221> CHLORIDE AND SULFATE

Where the individual monograph calls for applying the test to a specific volume of a solution of the substance, and the limit for chloride or sulfate corresponds to 0.20 mL or less of 0.020 N hydrochloric acid or sulfuric acid, respectively, apply the test to the solution without further dilution.

Learn More

PDF IS 3025 (Part 24): Method of Sampling and Test (Physical

IS : 3026 (Part 24 )-1986 3.6.7 Stocle sulphate solution (100 mgll ,ScYi) - Dissolve 1.479 9 anhydrous sodium sulphate (Ns2SO . .) (dried at 110°C for 1 hour) in distilled water and make up to 1 litre in volumetric flask. 3.6.8 Standard sulphate solution - Prepare a series of· standard solutions by diluting stock solution of sulphate with distilled water.

Learn More

Sulfate content of concrete | Nicholls-Colton

Testing can be carried out on concrete dust or lump/core samples, the result being expressed as the percentage sulfate by mass of cement in a sample, industry standards recommending a limit of 4.0% for this value.

Learn More

Determination of sulphate by pH titration - ScienceDirect

The procedure consists of three pH titrations: one with a test solution of known sulphate content, the second with the sulphate sample, and the third with a blank. This method can be used in the presence of several inorganic ions and organic matrices, including non-aqueous solvents.

Learn More

Sulphate content , Soil testing equipment, Controls

Laboratory method - Ion exchange apparatus (BS 1377:3) Used for determining the sulphate content of ground water and aqueous soil extracts. It consists of a ion exchange column 400 mm long and 10 mm dia., a swan-neck outlet and a 1500 ml round bottom flask to give a constant head. The apparatus is supplied assembled on a stand.

Learn More

Limit Test for Sulfates Principle and Experimental Procedure

2019/09/11 · The turbidity produced by test sample is compared with of standard solution again dark background. The procedure of limit test for sulfate. Dissolve 2gm of the test sample in 10ml of distilled water in a Nessler’s tube. Add 2mlof dilute hydrochloric acid to the solution. Dilute to 45 ml with distilled water and add 5ml of barium sulfate reagent.

Learn More

TEST METHOD FOR MAGNESIUM SULFATE SOUNDNESS OF GRANULAR MATERIALS

sieve shaker to obtain exact "before test" sample weights. D. Weigh the test samples and set aside or discard excess material over the maximum test weight required for each sample in E. below. E. Final "before test" sample weights shall be as follows: 2 in. to 1 in. (50 mm to 25 mm) size 2100 ± 100 g

Learn More

THRESHOLD SULFATE LEVELS IN SOILS | Recommended Practice

Although volumetric swell tests are valuable, it is also necessary to have a reliable measure of the sulfate content and to link that level to a threshold risk. The sulfate concentration should be determined based on an accepted specification such as AASHTO T 290 (modified), which is discussed later in this report.

Learn More

IS 3025 (Part 24): Method of Sampling and Test (Physical and

3.6.7 Stocle sulphate solution (100 mgll ,ScYi) - Dissolve 1.479 9 anhydrous sodium sulphate (Ns2SO . .) (dried at 110°C for 1 hour) in distilled water and make up to 1 litre in volumetric flask. 3.6.8 Standard sulphate solution - Prepare a series of· standard solutions by diluting stock solution of sulphate with distilled water.

Learn More

AASHTO T 290 - Standard Method of Test for Determining

This test method covers the determination of the water-soluble sulfate ion content in soil. This standard is divided into two parts. The first part specifies the procedure for sampling and preparing the sample to size for testing. The second part delineates two test procedures (Methods A or B) for the determination of the sulfate ion content in

Learn More

Sulfate Test Strip at Thomas Scientific

Method: colorimetric with test strips 200 - 400 - 800 - 1200 - 1600 mg/l SO 4 2- MQuant™ Storage class: 10 - 13 Other liquids and solids Storage Store: at +15°C to +25°C. The sulfate test can be used to give a rapid estimation of the sulphate ion content

Learn More